Basic Firmware Commands
Connecting to Console
This section introduces basic commands for system checks and debugging via Celestica's Firmware Console Port Connection Setting.
Tera Term is recommended for connecting, but before the first connection install the appropriate TPYEC-UART device driver.
The device driver available for CP2108 is the Virtual COM Port (VCP) driver. The latest drivers are available at https://www.silabs.com/search#q=TPYEC-UART%20Virtual%20COM%20Port%20driver&t=All&sort=relevancy .
When connecting, choose the COM port and set the Baud rate to 115200. Also apply the other values as listed below.
Attribute | Value |
---|---|
Baud Rate | 115200 |
Date | 8 bit |
Parity | None |
Stop | 1 bit |
Flow Control | None |
Interface0: SES UART (Debug, refer to the Nebula G2 SES FW User Guide)
Interface1: BMC UART (Debug, refer to the Nebula Gen2 BMC User Manual)
-
Username: sysadmin
-
Password: superuser
-
Baud rate: 115200
NOTE:
System Information Commands
Use command "fru get" to check system information.