home

Storage

NetworkingStorageSoftware
NetworkingStorageSoftware

Celestica Documentation Portal

Find your product documents here

Show Contents

thumbnailStorage

SC6110

CPU Installation

  1. Unscrew the captive screw to open the CPU socket frame.
    Note: The CPU backplate and CPU socket are pre-installed and are not removable parts.
  2. Remove the pre-installed plastic cover.
  3. Insert the CPU into the CPU socket by aligning the A1 corner of the CPU with the A1 corner of the socket.
    Warning: The pins of the CPU are extremely fragile. Be very careful when installing.
  4. Close the CPU socket frame and torque the captive screw to 13.8 kgf-cm (12 in-lbf).
  5. Remove the plastic protective cover from bottom of the heatsink.
  6. Ensure the thermal grease is evenly spread across the base of the heat sink.
  7. Align the CPU heatsink over the CPU socket and set it in place.
    CAUTION: Be sure the heatsink is aligned properly with the system airflow. Failure to do so may cause system to overheat, resulting in system damage.
  8. Insert all six screws and carefully engage the threads. Do not torque to final specifications until all six screws are started.
  9. Using a Torx T20 bit driver, adjust the screwdriver torque setting to 12 in-lbf.
    Follow the torque pattern shown in below image (numbers 1-6).

Last updated: September 17, 2025