show interface

Displays information for one or all Ethernet interface.


Syntax	`show interface [Ethernet <if-id>]`
Command mode	EXEC
Parameters	`if-id` – Interface identification number.
Usage	Use `show interface` to display all the interface information.
Supported Releases	1.1.0 or later
Click command	None
Example sonic# show interface Ethernet 0 Ethernet0 is up, line protocol is down Hardware is Eth Interface index is 1 Mode of IPV4 address assignment: not-set Mode of IPV6 address assignment: not-set IP MTU 9100 bytes LineSpeed 1GB, Auto-negotiation Enabled Input statistics: 0 packets, 0 octets 0 64 byte pkts, 0 65-127 byte pkts, 0 128-255 byte pkts 0 256-511 byte pkts, 0 512-1023 byte pkts, 0 1024-1518 byte pkts 0 Multicasts, 0 Broadcasts, 0 Unicasts 0 pause, 0 oversize, 0 throttle 0 fragment, 0 jabber, 0 undersize 0 error, 0 discarded, 0 unknown-protocol Output statistics: 0 packets, 0 octets 0 64 byte pkts, 0 65-127 byte pkts, 0 128-255 byte pkts 0 256-511 byte pkts, 0 512-1023 byte pkts, 0 1024-1518 byte pkts 0 Multicasts, 0 Broadcasts, 0 Unicasts 0 pause, 0 oversize, 0 throttle 0 error, 0 discarded

Celestica Documentation Portal