Pre-Installation Information
There are several considerations to keep in mind when installing a rail kit in a server rack. Following these recommendations will ensure a successful installation.
- Elevated Operating Ambient Temperature
-
If installed in a closed or multi-unit rack assembly, the operating ambient temperature of the rack environment may be greater than room temperature. Therefore, consideration should be given to installing the equipment in an environment where the chassis does not exceed the maximum ambient temperature (Tma) specified.
- Reduced Air Flow
- Installation of the equipment in a rack should be such that the amount of air flow required for safe operation of the equipment is not compromised.
- Open Rack Mounting
- Care should be taken to prevent the rack frame from obstructing the ventilation openings. Be sure to check the chassis positioning after installation to avoid overheating.
- Circuit Overloading
- Consideration should be given to the connection of the equipment to the supply circuit and the effect that overloading of the circuits might have on over-current protection and supply wiring.
- Reliable Grounding
- Reliable grounding (earthing) of rack-mounted equipment should be maintained. Particular attention should be given to supply connections other than direct connections to the branch circuit (for example, use of power strips).
For safety, a rack should should always be loaded from the bottom up. That is, install the equipment that will be mounted in the lowest part of the rack first, then the next higher systems, etc.
If a standard 19'' rack is not available, DS5000 can be placed on a clean, stable, and level surface. Leave a clearance of 100mm (~4 inches) around the chassis for ventilation. Do not place anything on top of the chassis.