Power Supply Unit (PSU)
Overview
The SC6100 storage controller is powered by two (2) redundant 1+1 power supply units (PSU) allowing full operations to continue in the event should one fail. A failed PSU should be left in the system until a replacement part is available to be used.
- Input: 200-240VAC nominal via IEC 320C-14 power inlet, this inlet is rated for 10A/250VAC
- 1+1 Redundant 2400W CRPS PSU
- 80plus Titanium efficiency
- Hot-pluggable
- 40mm (H) × 265mm (D) × 73.5mm (W)
CAUTION: When a controller is unseated from the system, the system will continue to operate via the PSU supplied in the remaining controller and its power cord. Use caution not to disturb the remaining controller and power cord.
CAUTION: Only use PSUs with identical part numbers. Failure to do so will cause a system error.
CAUTION: In the event of a PSU failure, do not remove it until ready to install an identical replacement.