dead interval

Sets the interval time after which a neighbor is declared down.


Syntax	`ip ospf dead-interval <dinterval>`
Command mode	Interface (Ethernet, PortChannel, VLAN and Loopback)
Parameters	`dinterval` – Delay interval in seconds. Range: 1 – 65535.
Usage	Use `no ip ospf dead-interval <dinterval>` to remove the configuration.
Supported Releases	1.1.0 or later
Click command	None
Example `sonic(conf-if-Ethernet8)# ip ospf dead-interval 10 sonic(conf-if-Ethernet8)# no ip ospf dead-interval 10`

Celestica Documentation Portal