Attaching the Chassis Bracket

Separate the inner and outer brackets.
1. Fully extend rail.
2. Move white tab to release the two halves of the rail.
If not installed, attach the M4 standoff screws provided in the accessory kit to both sides of chassis.
Align outer bracket with chassis holes (chassis left is same as right).
Slide outer bracket towards back of chassis to lock it in place.
Lock outer bracket with M4 screw (PH#2 slotted screwdriver)
Push the chassis with the outer bracket locked in step 1 above from the front side by one person, and push the inner bracket into the outer brackets (sleeve) slot on the chassis from the rear side by another person at the same time, until guide pin (detail 1) and inner bracket guide pin (detail 3) fit in rack square holes. Then, lock them with M6 screws (PH#3 slotted screwdriver).
Ensure there is adequate clearance around the switch to maintain proper air circulation.
Repeat for opposite side.

Celestica Documentation Portal