DS1000 Product Overview
This document describes the general hardware design of the DS1000 Ethernet switch.
An Open Compute Project (OCP) accepted design, the DS1000 Ethernet switch offers 48 x 10/100/1000Mbps RJ45 ports and 8 SFP+ ports within a 1U form factor.
Optimized for:
- GbE Data Center Top of Rack
- Enterprise Edge/Access
- Management Switch Use Cases
Product Specifications
| Type | DS1000 |
|---|---|
| Depth | 370 mm |
| Height | 43.6 mm |
| Width | 438.5 mm |
| Weight | 7.1Kg |
| Power Input (VAC) | |
| Power Consumption (W) | <100W |
| Operating Temperature (airflow front to back) | 5 - 40 ºC |
| Operating Temperature (airflow back to front) | 5 - 40 ºC |
| Operating Relative Humidity | 40 - 60 % |
| Storage Temperature | -40 - 70 ºC |
| Storage Relative Humidity | 5 - 95 % |
Networking Capabilities
- ACL
- The DS1000 Ethernet switch supports comprehensive ACL policies. Traffic can be classified by source/destination IP addresses, source/destination MAC addresses, IP protocols, TCP/UDP, IP precedence, time ranges and ToS. Various policies can be conducted to forward the traffic. The DS1000 Ethernet switch also supports IEEE802.1x port-based access authentication, which can be deployed with RADIUS, to ensure port level security and block illegal users.
- QoS
- DS1000 fully supports the DiffServ module. Users can specify a queue bandwidth on each port. WRR/SP/SWRR scheduling is also supported. DS1000 supports port security. Users can deploy trusted CoS, DSCP, IP precedence and port priority. Traffic can be classified by port, VLAN, DSCP, IP precedence and ACL table. Users can also modify packets' DSCP, COS, and IP precedence values. Users can specify different bandwidths for voice/data/video to customize different qualities of service.
- MPLS Ready
- DS1000 supports LDP and MPLS VPN which can be used in metropolitan area networks and wide area networks.
Features
-
1U Form factor
-
48 x 10/100/1000Base-T RJ45 Copper ports, 8 x SFP+ 10Gigabit fiber ports, 1 x Console Port base on RJ45, 1 x Out of band management port base on 10/100/1000Mbps RJ45, 2 x Type A USB 2.0 port
-
Intel Denverton 4-Core; 4GB ECC DDR4, configurable to 32GB; 64Gb iSLC M.2 configurable SSD
-
ONIE installer to support third-party network operating systems
-
Under 200W peak consumption, 1+1 redundant hot swap PSUs; 90-264VAC 47Hz/63Hz AC/DC PSU
-
Excess of 150,000 hours
| DS1000 | Supported Technologies |
|---|---|
| Standards | 802.1d/w/s, 802.1Q, 802.1p, 802.3ad, 802.3x, GVRP, DHCP and SNTP |
| Protocols | IGMP, DVMRP and PIMRIPv1/2, OSPF and IPv6 |
| Interfaces | 1x console port, 1x management port, 2x Type A USB 2.0 ports |
Product Orientation
Note: The USB port supports data transmission only. It does not supply power.
Note: The user can perform local and telnet configuration through this port. The console port supports asynchronous mode, 8 data bits, 1 stop bit, no parity bit. The default baud rate is 115200 bps.